RTD Embedded Technologies, Inc. PC104 and PC104 plus embedded computers Home Page RTD Product Menu Single Board Computers Digital Signal Processing Frame Grabber SVGA Panel DVI MPEG Bluetooth WLAN 802.11 Cellular GSM GPRS GPS-Rail Ethernet Quad Serial CAN Bus USB 2.0 Modem PCMCIA GPS Hard Drives Power Supplies IDE & Floppy Up to 16 Bit Resolution 8 differential or 16 single ended inputs 16-bit 200 kHz throughput outputs FIFO buffer Channel Gain Table Pacer & Burst Clocks Programmable Gain Bit Programmable Opto-isolated Timer/Counters Incremental Encoders Servo Motor Control Synchro / Resolver DC/DC Isolated Avionics IDAN HiDAN HiDANplus Return to RTD's Home Page

Additional HiDAN™ Features

Gel Gasket Material for sealing between sleeves


Fig 1: Cross section of integrated tongue and groove configuration with gel gasket

·         Raychem GelTek EMI Shielding Gasket Part #EMI-CSI-M3-0063_R10-S

·         Circular Silicone gel material 0.063" in diameter

·         Metal type - Monel circular knit (Monel is a nickel and copper alloy that has good conductivity while resisting deformation)

·         Provides reliable shielding against high levels of electromagnetic interference and electrical grounding.  85dB minimum from 10 - 1000 MHz

·         Rated to 30 PSID.

·         Tacks instantly and requires no cure cycle.

·         Seals bimetallic contact points from moisture to protect against galvanic corrosion.

·         Operating temperature range -55°C to 125°C

 

Circular I/O Connectors

MS27468T MF 35PA


Fig 2: Cross section of MIL-C-38999 Series I connector

·         MIL-C-38999 - Standard connector offering environment-resistant to sand, dust, and ice.. Operating temperature range -65°C to 175°C.  Designed to operate between sea level to 100,000 ft. above sea level. 

·         EMI shielding greater than 90dB @ 100 MHz and greater than 65dB @ 10 GHz.

·         Corrosion-resistant shells of aluminum alloy with cadmium over nickel.  Insulator is made of high grade plastic, contacts are copper alloy with gold plating, and sealing is accomplished using a Jam nut receptacle with a silicone base elastomer grommet.  The mounting jam nut is an aluminum alloy. 

·         Standard MIL-C-39029 contacts, MIL-I-81969 application tools and MIL-STD 1560 insert arrangements.  Rear release crimp snap-in contacts.

·         Shell size is 17 with 55 #22 pins, an outside diameter of 1.101" and extends from the HiDAN approximately 0.720".

·         These connectors have polarizing key for alignment and to prevent similar mating connectors from being mated to the wrong connector.

Description             General Specifications               Image Gallery 

 System Construction       Dimensional Drawings               Shock Mount   

 SYSTEMS                     PC/104 Menu                           Home            

Copyright © 1998-2008 RTD Embedded Technologies, Inc.  All rights reserved.